StableBit DrivePool Q2150495
From Covecube - Wiki
Revision as of 17:24, 24 September 2013 by Christopher (talk | contribs) (Created page with "==When to Use== If you are getting the dreaded "StableBit DrivePool cannot load some of the data coming from the remote computer" error. This is caused by a corruption in the pe...")
When to Use
If you are getting the dreaded "StableBit DrivePool cannot load some of the data coming from the remote computer" error.
This is caused by a corruption in the performance counters, which we use for DrivePool
Steps
- Follow: Q7200705
- Launch an elevated command prompt
- Note: hit the Windows button, type "cmd", and it should show "Windows Command Processor", right click on this and select "Run as Administrator"
- Run "lodctr /r" to rebuild the Performance Counters
- Note: you may need to run this a couple of times to get it to complete. If it still doesn't, reboot and try again.
- Run "lodctr /e:PerfDisk" to make sure that the disk counters (what we use specificially) is enabled.
- Reboot the system to make sure the changes have taken.